3D Celtic Medallions

You Will Need:

Tools

3D Foam Pads or Silicone Glue
Double Sided Tape
Scissors
Craft Knife - For placing tiny peel offs
Tweezers - optional

Look carefully at the stickers and you will see there are two types of medallions on each sheet. One of them has narrow spaced lines so the foil colour is dominant with very little glitter showing. The other has widely spaced foil lines with glitter between them. Using a combination of the two makes the design very beautiful.

Stick one narrow width medallion onto the centre of the white deckled card panel then add a 3D foam pad to the centre.

Place a wide medallion onto the acetate and cut it out.

Peel the backing away from the foam pad on the bottom medallion. Hold the acetate medallion over the panel and twist round so that the lines in the medallion beneath are offset. Lower carefully in place. If you find your fingers get in the way, use a pair of tweezers to position the medallion. Add another 3D foam pad to the centre.

Place a medallion middle onto the acetate and a star in the middle of it. Cut it out. Peel off the backing from the 3D foam pad then hold the piece above the panel. Centre the piece aligning the points with the narrow medallion on the bottom layer.

You can complete the design by adding a star in a contrasting colour.

Use double sided tape to stick the stardust glitter backing papers and medallion panels onto the cards. The examples shown are only three ideas of how to layout the cards. Use the leftover peel offs to decorate the cards.

Download a printer friendly copy of this project.

You will need a copy of Acrobat Reader to open the file. If you do not already have a copy you can download one from http://www.adobe.com/products/acrobat/readstep2.php

BGPayne Crafts