Dimensions Birthday 1

You Will Need:

Window Card

Cut a 4cm square from the centre of the card. To do this cut a piece of scrap card to 5.25cm wide and use it as a template to draw lines 5.25cm from each edge of the card, leaving a 4cm square in the centre. Then cut out the square with a craft knife.

Carefully sperate the two layers of the square embellishment. Stick the top layer around the window. Stick the bottom layer inside the card so that it shows through the window.

Stick the four corner embellishments onto each corner of the front of the card. Stick border peel offs about 1cm from each edge of the card. Another template 1cm wide will make positioning of the peel offs easier.

Squares Card

Cut the iliac and baby blue papers to 7.25cm square. Use double sided tape to stick them onto the card as shown. Run the edges of the card across the surface of the lilac and blue ink pads to apply colour to the very edges of the card. Stick lengths of ribbon over the raw edges of the paper as shown. Stick on the embellishments as shown in the picture.

Baby Wish Card

Use fancy scissors to cut 5cm off the right hand edge of the front of the card. Use a green ink pad to sponge colour onto the front of the card. Run the edges of the card across the red ink pad. Stick a sheet of 14.5cm square pink paper to the inside of the card. Apply the embellishments as shown.

Download a printer friendly copy of this project.

You will need a copy of Acrobat Reader to open the file. If you do not already have a copy you can download one from http://www.adobe.com/products/acrobat/readstep2.php

BGPayne Crafts