4 Berriedale Road
Nelson
Lancashire
BB9 8AX
UK
01282 691090
bridie@bgpayne.com
Open 10am - 4pm
Tuesday - Saturday
UK orders are usually
delivered within 10 days,
but please allow
up to 28 days.
Use Glue Dots to stick the ribbon down the length of the card. These are perfect for sticking on such delicate backing sheets. Place the ribbon onto the sheet of glue dots and press it down using the glossy backing sheet to prevent getting the glue dots on your fingers, then press it onto the card.
Thread some of the beads onto the wire wrapping it around the first and last beads to secure it. Bend the wire into a wave shape. Use 3D foam pads to stick the beaded wire onto the card.
Cut some of the corrugated card to 6cm square and stick it to the card. Cut some of the woven backing to 5cm square. Use glue dots to stick this on top of the corrugated card. Stick a eddy shape on top of the panel. Tie the ribbon into a bow and stick it to one corner of the panel. Complete the card with a peel off greeting.
Cut some strips if scrap card to the following widths:- 1cm, 4cm, 5cm, 2cm and 2.5cm. Use these scraps like a ruler to draw lines on a piece of scrap card the same size as your card. There should be three squares the top one 1cm down from the top of the card, 1cm in from the right hand side and 4cm from the left. The bottom square is just the same but a mirror image. The middle square is 2cm from the top and bottom squares and 2.5cm in from each side of the card.
Use a craft knife and cutting matt to cut out the three 5cm squares you have drawn. Use masking tape to secure your template to the back of the front panel of the cream card. Use an embossing tool to emboss the squares.
Cut three 4cm squares from the backing paper and stick them onto the embossed panels. Cut the woven backing to 3.5cm square and use glue dots to stick them in place. Stick embellishment onto the panels as shown. Use craft glue to stick some of the sequins around the card.
Download a printer friendly copy of this project.
You will need a copy of Acrobat Reader to open the file. If you do not already have a copy you can download one from http://www.adobe.com/products/acrobat/readstep2.php