Gold

You Will Need:

Window Card

Cut a 4cm square from the card. To do this cut a scrap of card to 3cm wide and use it like a ruler to mark lines 3cm in from each side of the card and 3cm in from the top. Mark another line 4cm below the last one. Use a craft knife and cutting mat to cut out the 4cm square you have drawn.

Cut some of the dotted backing paper to 10cm square. Use double sided tape to stick it to the bottom of the card. Cover the raw edge of the paper with a border peel off. Put more border peel offs around the edge of the square aperture.

Stick a daisy inside the card so that it shows through the aperture. A peel off greeting completes the card.

Daisy Strip Card

Punch each corner of the card using the Victorian corner punch. Cut a strip of the dotted paper to 10cm by 2cm and stick it to the card about 6cm from the top of the card. Tie the gold cord around the spine of the card.

Stick a daisy onto the dotted strip and finish the card with a peel off greeting.

Random Hearts Card

Cut the backing material to 6cm by 11cm and stick it to the card. Glue Dots Micro Dots are ideal for sticking down this type of material. Place the backing sheet onto the sheet of glue dots and press it down using the glossy backing sheet to prevent getting the glue dots on your fingers.

Tie the gold beading into a bow and stick it to the corner of the backing using a 3D foam pad. Stick a daisy to the opposite corner. Randomly stick hearts onto the backing using 3D foam pads or Glue Dots. Complete the card with a peel off greeting.

Download a printer friendly copy of this project.

You will need a copy of Acrobat Reader to open the file. If you do not already have a copy you can download one from http://www.adobe.com/products/acrobat/readstep2.php

BGPayne Crafts

Gold

You Will Need:

Window Card

Daisy Strip Card

Random Hearts Card