Handcrafted Wedding Bride

You Will Need:

Wedding Dress Card

Cut a piece of ivory card to 9.5cm square and stick it onto the card as shown. Cut some white card to 9cm square and use 3D foam pads to stick it on top of the ivory card.

Use border peel offs to embellish the card as shown.

Stick the wedding dress onto the centre of the card.

Square Panels Card

Cut some strips of scrap card at least 15cm long to 2.75cm and 4cm wide. A paper trimmer makes this much easier than a craft knife and cutting mat. Using the card lengths like a ruler draw lines 2.75cm in from each edge of the card on the inside front panel. Then draw lines 4cm in from each of the lines you have just drawn. Use a craft knife, ruler and cutting mat to cut out the four squares you have drawn. If your edges are a little rough you can smooth them down with the back of a teaspoon or for more accuracy use an embossing tool.

Cut four 3.5cm squares from the ivory card. Put a tiny bit of double sided tape in each corner of each square and stick them over the apertures. Next cut four 3cm squares from the white card and stick them to the fist squares as shown.

Stick an embellishment to the centre of each square.

Complete the card with a peel off greeting.

Download a printer friendly copy of this project.

You will need a copy of Acrobat Reader to open the file. If you do not already have a copy you can download one from http://www.adobe.com/products/acrobat/readstep2.php

BGPayne Crafts